Suchiyu SCY 18101 Parts Receiver ESC 8047 (Brushed Version)

Brand: Suchiyu

Product Name: Brushed receiver

Product number: 8047

Accessories materials: electronic components

Quantity: 1pcs, as picture

Applicable to: Suchiyu 18101 1:18 full scale remote control four-wheel drive Bigfoot vehicle.

2S 25 AIntegrated Electrical Modulation, Brushed version

It can only be used on brushed version cars, not brushless version cars.

What is the difference for SCY 18101 and 18101PRO rc car?

SCY 18101 is a brushed version,

The SCY 18101PRO is a brushless version

Their electronic accessories are different, the differential is different, the gear is different, the rotation shaft is different, and the other basic accessories are the same.

After replacing the new circuit board, how to bind to the remote controller?

Slide the ON/OFF switch to switch on thetransmitter. Press and hold the button on theESC/Receiver for 2-3 seconds to  switch onthe

ESC/Receiver.The transmitter indicatorturns into at this time often bright, hint issuccessful to the code.

Normally, the correct operation steps to end the operation of the model car are:

Step 1: Press and hold the button on the ESC/Receiver for 2-3 seconds to switch offthe ESC/Receiver. Press and hold the button on the ESC/ receiver for 2-3 seconds to switch offthe ESC/ receiver.

Step 2: Slide the ON/OFF switch to switch off the transmitter.

Common questions and solutions for model cars:

Why can't the remote control car move?

1. The model is of low battery.

2. The engine or the motoris damaged.

4. The electronic speed regulator is damaged.

5. The wire is damaged.

Processing Method: Please reconnect the damaged part and insulate it.

6. The connector is isdamaged.

Processing Method: Please check whether the power cord of the motor isdisconnected.  lf yes,re-weld it.

7. The power connector is isloose.

Processing Method: Please check whether the contact between connectors ofeach part is loose.   

lf yes, please re-plug and fix them.

Why did the car lose control?

1. Whether the model or theengine is of low battery.

Processing Method: Please charge the model batteries, or put in fully-charged batteries, or replace them with new engine batteries.

2. The receiver isdamaged.

3. There lacks torsion.

Processing Method: Please apply lubricant to the moving members.

4. The rotating member isnot lubricated properly.

Processing Method: Please check whether the steering gear is out of order, andreplace it with a new one when necessary.

5. The steering part is isdamaged.

Processing Method: The swing arm on the steering gear is damaged.  Pleaseconfirm whether to replace it with a new one.

6. The rotating member isnot assembled properlyor is worn.

Processing Method: Please troubleshoot carefully the part that fails,  and checkand re-assemble it.    lIf the gear or any other accessory is badlyworn,please replace it with a new one.  Disassembly andassembly may refer to the proper instructions in the manual.

If you need a remote transmitter, click here: 8048 transmitter

If you need a brushless ESC, please click here: 8054 ESC